Error message

August 31, 2004, 08:54

Hello Everybody,

I am getting this message. The calculation starts, but does it mean that it will not take into account the wall boundary conditions? How do I increase the NTWPOS?

*** YOU ARE RUNNING DOUBLE PRECISION VERSION *** NTWPOS: MEMORY ALLOCATED: 0 . MEMORY REQUIRED: 4

*** WARNING #122 *** INSUFFICIENT MEMORY ALLOCATED IN parm.inc TO OUTPUT WALL DATA IN .pst FILE.

INCREASE NTWPOS OR WALL DATA WILL BE IGNORED.

Thank you for your help.

September 2, 2004, 11:10

Would you help me? Is this error indicating that my solution will be wrong? The model is huge, but it seems to converge...

Thank you for any help

September 2, 2004, 14:15

Did you by any chance switch on the output of wall data AFTER writing the .geom file? And then not write a new .geom file?

That could cause your parm.inc to have the wrong dimensions.

Try deleting parm.inc, open Prostar, RESUME, execute GEOM and PROB, SAVE and try again.

September 2, 2004, 11:10	Re: Error message - NTWPOS!!!!	#2
new-user Guest Posts: n/a	Would you help me? Is this error indicating that my solution will be wrong? The model is huge, but it seems to converge... Thank you for any help

September 2, 2004, 14:15	Re: Error message	#3
Brian Guest Posts: n/a	Did you by any chance switch on the output of wall data AFTER writing the .geom file? And then not write a new .geom file? That could cause your parm.inc to have the wrong dimensions. Try deleting parm.inc, open Prostar, RESUME, execute GEOM and PROB, SAVE and try again.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Error message-Floating point error	Vaibhav	FLUENT	3	December 7, 2007 05:38
ERROR MESSAGE: line 1: parse error	Lourival	FLUENT	1	February 18, 2006 01:35
help on error message	zwdi	FLUENT	1	January 10, 2004 22:58
Error message	RM	FLUENT	2	January 8, 2004 06:05
Gambit 2.0 - Error Message (ACIS ERROR 1200)	James	FLUENT	1	May 14, 2003 08:13

August 31, 2004, 08:54	Error message	#1
new-user Guest Posts: n/a	Hello Everybody, I am getting this message. The calculation starts, but does it mean that it will not take into account the wall boundary conditions? How do I increase the NTWPOS? * YOU ARE RUNNING DOUBLE PRECISION VERSION * NTWPOS: MEMORY ALLOCATED: 0 . MEMORY REQUIRED: 4 * WARNING #122 * INSUFFICIENT MEMORY ALLOCATED IN parm.inc TO OUTPUT WALL DATA IN .pst FILE. INCREASE NTWPOS OR WALL DATA WILL BE IGNORED. Thank you for your help.