|
[Sponsors] |
May 11, 2005, 17:19 |
Trimmed mesh in Proam
|
#1 |
Guest
Posts: n/a
|
Hello everybody,
I am new to proam or you can say StarCD. I have imported a 3D mesh in StarCD from gambit. I wanted to try the automated mesh generation technique on this using proam. Can this be acheived using graphical tools in StarCD or is there no was running from commands. Thanks in advance. Regards Sam. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
problem in mesh generation-PROAM | Bala | Siemens | 0 | February 21, 2008 04:27 |
trimmed mesh | Tester | Main CFD Forum | 0 | January 6, 2008 11:32 |
Ngeom Crashing on Trimmed / Hexahedral Mesh | Fr Ted Crilly | Siemens | 2 | October 13, 2005 07:08 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
trimmed mesh | novice | Siemens | 5 | April 18, 2005 03:32 |