problem in mesh generation-PROAM

Bala

Hi Tom and Pauli,

Thanks for your suggestions! I checked my surfaces and i did some corrections, infact i am getting the good subsurface than the earlier one. So i increased my sub surface to 500mm. But after generating the mesh with max edge length 350 and min edge length 10 mm. I am not getting the complete mesh. Its showing some unresolved cells and the mesh also not between the surface and the domain (doing external flow analysis). I think the problem is due to the error which i am getting as below. How to set the global tolerance.

Warning: 0.01 * minimum edge length is less than global

tolerance. The global tolerance is set to 0.0364453.

This setting may cause geometry detail in both

the surface and resulting model to be lost or

result in more unresolved cells.

Could you plz reply for this?

Bala