Home > Forums > Software User Forums > Siemens

How to make shell from Section Slice

Mark Forums Read

Reply

Search this Thread

July 7, 2006, 06:43	How to make shell from Section Slice	#1
A.S. Guest Posts: n/a	Hi, I take section slices at certain post-processing locations. Can I make shell out of section slice to get some avaeraged values there. If possible please let me how to do it. Thanks A.S.

July 7, 2006, 11:03	Re: How to make shell from Section Slice	#2
William Blake Guest Posts: n/a	pscreate ...

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[General] Average of SLICE in Paraview	Maurice Waldner	ParaView	6	December 16, 2018 18:41
Averaging pMean by slice	cedric_duprat	OpenFOAM Post-Processing	0	September 19, 2008 11:10
Bounded slice in Tecplot possible?	Sam	Tecplot	1	August 20, 2008 13:18
Section Slice in ProStar	benbru	Siemens	1	February 8, 2008 16:59
Tecplot Slice	Alex	Tecplot	2	April 28, 2006 09:28

All times are GMT -4. The time now is 18:42.