|
[Sponsors] |
April 2, 2007, 21:11 |
pro-am stuck
|
#1 |
Guest
Posts: n/a
|
Has anyone else experienced their Pro-AM stuck? I mean say u set your processes "complete" in mesh wizard then u go home and hope that it will run overnight. But when u come back next morning it was stuck in 2nd step. However, the same template processes have been done many times before (during office hours) and the whole thing should complete in 1 hour. So why was it stuck for more than 12 hours?
Earlier suggestions have been to adjust screen saver and monitor hibernating.. but still this problem occurs. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FloWorks Solver stuck | Daniel | FloEFD, FloWorks & FloTHERM | 3 | September 17, 2008 15:20 |
Please help...I get stuck in an error!!!! | Gordon | FLUENT | 4 | August 26, 2008 20:39 |
pro-am stuck | azmir | Main CFD Forum | 1 | April 2, 2007 21:12 |
PLEASE PLEASE ADVICE..KINDA STUCK | Nanda | FLUENT | 10 | July 25, 2006 07:57 |
stuck onto wall | guang ai | Siemens | 0 | March 30, 2003 19:04 |