|
[Sponsors] |
March 14, 2008, 05:10 |
vcex
|
#1 |
Guest
Posts: n/a
|
Hi, just a small question but which is giving me headache for 3days...after applying the vcex command for one layer from a set of patches defined before, i cannot see the fluid cells extruded...it is writing that they exist, but i cannot plot them on the screen. i've tried all the possibities that i know but i can only plot the shell cells and the vertices?! can anyone give me a clue?! thanks! regards, lelia
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
VCEX CCM+ | norbinou | Siemens | 4 | February 19, 2008 05:55 |