|
[Sponsors] |
August 25, 2008, 03:20 |
Meshing in tip clearance.
|
#1 |
Guest
Posts: n/a
|
Hi all, I am doing compressor cfd analysis. I would like to know, how can I mesh in tip clearance. Tip clearance betwwen blade tip and casing is around 0.18 mm, and I have to also create interface (may be at 0.09 mm) within this distacnce to capture near wall boundary resolution. My worry is how can I specify parameters . Does anybody has idea?
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem meshing turb. blade tip clearance geometry | Balu | FLUENT | 0 | June 7, 2008 21:10 |
Tip Clearance | Liam | CFX | 3 | September 7, 2005 05:30 |
K-e model and tip clearance | windacner | Fidelity CFD | 0 | April 25, 2004 21:10 |
Turbumachinary (Tip clearance) | Farokh Alipour | FLUENT | 0 | December 2, 2002 06:00 |
Tip Clearance | Drona | CFX | 0 | October 17, 2002 05:25 |