|
[Sponsors] |
Diesel combustion simulation ( Heat release rate) |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 25, 2009, 05:40 |
Diesel combustion simulation ( Heat release rate)
|
#1 |
Guest
Posts: n/a
|
I have one doubt in starCD regarding the heat release, when I do Combustion simulation of Turbocharged diesel engine using StarCD V3.26
When I use enthalpy option (Thermal models) as "Chemico thermal" , I am not getting heat release rate values in spd.01 file.(At every crank angle during combustion period, heat release values are plotted as zero in spd.01). Since combustion involves chemical reaction, I am using "chemico thermal" option as suggested by many people. If I use enthalpy option as "Thermal", I am getting heat release rate values. But Maximum temperature values at TDC ~2900k & average temperature inside the cylinder at TDC is 1450k. So Nox values obtained from StarCD are also higher than experimental values. But When I use enthalpy option as "Chemico thermal" I am getting maximum temperature value at TDC below 2400k which is acceptable. Only problem when I use "Chemico thermal" is, I am not getting heat release rate values at every crank angle. Is there is any other switch is available in Starcd 3.26 version to get heat release value? Or kindly request you to suggest me the procedure to get heat release rate values when I use "Chemico thermal" option. Thanks in advance |
|
March 16, 2009, 00:47 |
contact CD-adapco local support
|
#2 |
New Member
Join Date: Mar 2009
Posts: 2
Rep Power: 0 |
Hi Venkatesh
try to contact ur local cd-adapco office for more assistance on this issue |
|
April 29, 2009, 07:38 |
|
#3 |
New Member
mosheu
Join Date: Apr 2009
Posts: 14
Rep Power: 17 |
hi Venkatesh
which comb model do you use for diesel can I use EBU for diesel combustion did you close cfm or ecfm models in esice |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
heat release rate simulation | chiang | Siemens | 10 | April 29, 2021 06:10 |
heat release rate calculation | Karthick .K | FLUENT | 2 | April 28, 2021 22:15 |
Non-premixed combustion: local heat release rate | LB | FLUENT | 1 | April 28, 2021 22:11 |
Troubles with heat release rate | Xavier Ponticq | CFX | 4 | September 12, 2012 18:49 |
calculation of heat release rate | paul | Siemens | 3 | February 16, 2006 03:40 |