 |
 |
 |
|
|
|
[Sponsors] | ||||
August 16, 2019, 20:54
|
Surfactant spreading on the surface
|
#1 |
|
New Member
Yuxin Ye
Join Date: Aug 2019
Posts: 1
Rep Power: 0  |
Hi, I am currently using Comsol to simulate a drop of surfactant spreading on the free surface. But due to the nonlinearity of diffusion equation, I cannot get convergence answer. I am new to CFD. So can anyone give me a suggestion, like change it to Fluent will be better or write your own codes? I really think the problem here is common and hope anyone will give me a reply.
thanks. |
|
|
|
|
 |
| Tags |
| converge, converge error, convergence failure, spreading factor, surface tension |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Surface triangulation using snappyHexMesh | shaileshbg | OpenFOAM Meshing & Mesh Conversion | 4 | October 17, 2019 04:42 |
| [Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | OpenFOAM Meshing & Mesh Conversion | 3 | October 22, 2015 11:05 |
| [snappyHexMesh] Add additional boundary layers to complex stl surface | tobijingles | OpenFOAM Meshing & Mesh Conversion | 1 | October 26, 2011 10:45 |
| [Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |
| free convection heat transfer from a heated horizontal surface through a liquid to a thin cooled fin | Kaushik | FLUENT | 1 | May 8, 2000 06:47 |
Linear Mode
