 |
 |
 |
|
|
|
[Sponsors] | ||||
January 23, 2020, 11:00
|
Simflow
|
#1 |
|
New Member
Bisha
Join Date: Jan 2020
Posts: 2
Rep Power: 0  |
Hello!! Am quite new to this, I try to simulate a gas flow inside reactor using SIMFLOW. I start by representing a cylinder which is my reactor and I make the mesh, I want to know if I need to add the mesh "cell zone" for the iside area of reactor ?? PS my reactor is empty, there are no porous zone!! help plz am lost!!!
|
|
|
|
|
|
January 23, 2020, 21:12
|
|
#2 |
|
Senior Member
Svetlana Tkachenko
Join Date: Oct 2013
Location: Australia, Sydney
Posts: 407
Rep Power: 14 |
Could you please add a screenshot of the mesh?
|
|
|
|
|
|
|
January 24, 2020, 03:42
|
|
#3 |
|
New Member
Bisha
Join Date: Jan 2020
Posts: 2
Rep Power: 0 |
when I hide frontal mesh it seems empty, like we mesh only the reactor not what is inside Reactor.PNG
Reactor1.PNG |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] SimFlow 2.2 mesh created but not visible | MikeHersee | OpenFOAM Meshing & Mesh Conversion | 3 | September 18, 2016 09:29 |
| simFlow and water flowing from pipe | anraw | OpenFOAM | 0 | August 25, 2016 10:46 |
| simflow 2.0 has been released | newoscar | OpenFOAM Announcements from Other Sources | 2 | July 14, 2015 19:44 |
| simFlow 1.0 has been released | AnetaC | OpenFOAM Announcements from Other Sources | 10 | November 11, 2013 18:42 |
| simFlow release | AnetaC | OpenFOAM Announcements from Other Sources | 7 | October 6, 2013 14:41 |
Linear Mode
