Awaiting approval of Thread submitted 24 Hours ago

Lancez · October 15, 2021, 16:15

Hello, about 24 hours ago I submitted a question thread in the ANSYS Meshing & Geometry section but it was immediately sent for moderator approval. I assume this was because my post contained an image link to Imgur and was considered spam as a result.

I was hoping to get an idea of how long the approval process would take, as I am running a bit short on time. Also is there any way for me to view my post in the meantime? I would really like to see it. Thank you.

jola · October 15, 2021, 22:56

I have approved your new thread. Posts from new users are sometime sent for manual moderation when our spam-filters find something that looks suspicious, like an external link for example. Sorry about the delay.

October 15, 2021, 16:15	Awaiting approval of Thread submitted 24 Hours ago	#1
Lancez New Member Lance Join Date: Oct 2021 Posts: 2 Rep Power: 0	Hello, about 24 hours ago I submitted a question thread in the ANSYS Meshing & Geometry section but it was immediately sent for moderator approval. I assume this was because my post contained an image link to Imgur and was considered spam as a result. I was hoping to get an idea of how long the approval process would take, as I am running a bit short on time. Also is there any way for me to view my post in the meantime? I would really like to see it. Thank you.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ANSYS Workbench on "Uncertified" Linux Distros	hsr	CFX	289	April 20, 2023 10:23
udf problem	jane	Fluent UDF and Scheme Programming	37	February 20, 2018 05:17
Guide: Getting Started with the CFD Online Discussion Forums	pete	Site Help, Feedback & Discussions	8	July 29, 2016 06:00
Please check out my parallelized udf code	aleisia	Fluent UDF and Scheme Programming	0	June 10, 2011 17:16
Phase locked average in run time	panara	OpenFOAM	2	February 20, 2008 15:37

October 15, 2021, 22:56		#2
jola Administrator Jonas Larsson Join Date: Jan 2009 Location: Gothenburg, Sweden Posts: 856 Rep Power: 10	I have approved your new thread. Posts from new users are sometime sent for manual moderation when our spam-filters find something that looks suspicious, like an external link for example. Sorry about the delay.