|
[Sponsors] |
November 2, 2012, 13:31 |
Intake
|
#1 |
New Member
Flavio
Join Date: Nov 2012
Posts: 1
Rep Power: 0 |
Hi
Has anyone had any experience with engine air intake box simulation? I have set the intake boundary as pressure outlet for starters and the outlets as mass flow inlet, so I can set the mass flow on the outlet boundary and get the mass flow per filter on the inlet. The only thing is I keep getting the message of reverse flow on the boundary, which I understand must be because the air is actually going into the boundary, but also there is no convergence to the model and I don't know if that can be addressed because of the following: If I get the pressures this model generated (with oscilating residuals) and apply them to a pressure outlet boundary on the outlet now (changing from the original mass flow inlet), and change the inlet to a stagnation inlet, the model converges without any issue. But I need both cases to check uniformity on the outlet and uniformity on the inlet. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Scramjet+Ramjet Intake Simulation | mecbe2002 | OpenFOAM | 6 | January 17, 2020 13:40 |
[ANSYS Meshing] Air flow through intake manifold | zscheck | ANSYS Meshing & Geometry | 5 | March 15, 2012 21:41 |
Discharge control in an intake ! | ghmahtabi | Main CFD Forum | 0 | March 1, 2012 14:09 |
Modeling of a airflow in a intake manifold | Jack | FLUENT | 1 | September 21, 2003 22:22 |
designing an air intake under gambit | joseph guaragna | FLUENT | 0 | November 20, 2001 06:21 |