|
[Sponsors] |
July 21, 2012, 13:41 |
interface
|
#1 |
Member
David L
Join Date: May 2012
Posts: 43
Rep Power: 14 |
Hello everyone,
my problem, I have two pipes, the union between both is a interface (in place), I mean my first outlet with my second inlet in the second pipe. I have done "inizialize", all it is right, starccm+ recognizes the interface, but I get the Physics values in my second inlet that I write in the Physics values and not got the values from my first outlet. I attached picture. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |
CFX Solver Memory Error | mike | CFX | 1 | March 19, 2008 07:22 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |