|
[Sponsors] |
February 21, 2013, 00:15 |
Off drag coefficient
|
#1 |
New Member
Anonymous 92
Join Date: Feb 2013
Posts: 18
Rep Power: 13 |
Yes, hello, I'm currently working on the numerical analysis of flow around an Ahmed body with a rear slant angle of 35 using Star ccm+. I'm getting a value of 1 for the total drag coefficient when the validated value is around 0.25. I've more or less checked everything so I'm going to go with a error in the mesh. If it's the mesh or not the mesh, any suggestions on what could be the problem?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Drag Coefficient Convergence Problem | John | FLUENT | 18 | June 24, 2023 09:22 |
problem with saving drag coefficient | colopolo | FLUENT | 5 | April 12, 2013 10:59 |
Calculation of Drag Coefficient, Help Please | teek22 | CFX | 1 | April 26, 2012 18:41 |
Drag coefficient for parcels in dieselFoam | sebastian_vogl | OpenFOAM Running, Solving & CFD | 5 | December 31, 2008 12:19 |
Automotive test case | vinz | OpenFOAM Running, Solving & CFD | 98 | October 27, 2008 08:43 |