|
[Sponsors] |
June 25, 2014, 07:38 |
broken Prism layer
|
#1 |
New Member
Join Date: Apr 2014
Posts: 24
Rep Power: 12 |
Hello guys,
I want to keep it short and explain my problem with Prism Layer Mesher. After generating my Volume Mesh I get a broken Prism layer Mesh on my Geometry Here some pictures. Can someone explain why I don't get a correct Prism mesh? Thx. |
|
June 25, 2014, 18:02 |
|
#2 |
Senior Member
Join Date: Nov 2010
Location: USA
Posts: 1,232
Rep Power: 24 |
It looks like the prisms are having a hard time projecting on to a sharp corner, correct? You should modify the boundary march angle.
|
|
June 27, 2014, 03:16 |
|
#3 |
New Member
Join Date: Apr 2014
Posts: 24
Rep Power: 12 |
I've tried this before without any improvement.
I should also mention that this boundary represents an interface. The new boundary in the new picture represents a casing. |
|
June 29, 2014, 15:38 |
|
#4 |
Senior Member
Join Date: Nov 2010
Location: USA
Posts: 1,232
Rep Power: 24 |
I can't really tell what's going on. The first picture is far away and the next two are zoomed up somewhere. Can you post some more images?
|
|
June 30, 2014, 04:39 |
|
#5 |
New Member
Join Date: Apr 2014
Posts: 24
Rep Power: 12 |
Pictures:
1. water intake channel, interface,casing rotor 2. view inside water intake channel to interface 3. zoomed view inside water intake channel. 4. opposite view of 3 (outside of the water intake channel) 5. view inside intake channel to interface I think the geometry causes the problem as you can see in picture 3 und 4. What do you think? Thanks for your help. |
|
July 1, 2014, 13:19 |
|
#6 |
Senior Member
Join Date: Nov 2010
Location: USA
Posts: 1,232
Rep Power: 24 |
In this case, if what I think I'm seeing is correct, your prisms are moving from a 90 degree face to a face that's parallel to the interface. In the interface's case, no prisms will be projected onto the interface, the prisms will just collapse. There is no method around this unless you move the interface somewhere else.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Prism Layer (Boundary Layer) Thickness | Peter-27 | STAR-CCM+ | 12 | March 27, 2022 12:25 |
[ICEM] Holes in the prism layer | Airon | ANSYS Meshing & Geometry | 3 | September 12, 2013 06:08 |
ICEM Prism Layer transition between surface with prism layers and one without | TWaung | ANSYS Meshing & Geometry | 2 | October 12, 2009 14:56 |
Trimmer & prism layer | peresah | STAR-CCM+ | 6 | October 6, 2009 14:39 |
errors | Fahad | Main CFD Forum | 0 | March 23, 2004 13:20 |