|
[Sponsors] |
October 3, 2014, 08:34 |
Mesh problem in Starccm+ 9
|
#1 |
New Member
Xiaosong Zhang
Join Date: Oct 2014
Posts: 14
Rep Power: 11 |
I am new to this software, and I am trying to simulate the rotating motion of a vertical axis water turbine. After I set up the boundaries and regions, an error said"trimmer can not accommodate multiple regions in one continuum" shows up. What is the mistake of this?
|
|
Tags |
continuum, mesh generation problem, trimmer |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dynamic Mesh Problem. | Tom Clark | FLUENT | 10 | June 21, 2021 04:27 |
Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
Overset MESH problem DFBI 6DOF | Ale85 | STAR-CCM+ | 0 | October 1, 2013 12:25 |
[ICEM] ICEM Structured Mesh Problem | OMJT | ANSYS Meshing & Geometry | 3 | March 22, 2013 10:06 |
[GAMBIT] SOFC crossflow mesh possible problem??? | epc1 | ANSYS Meshing & Geometry | 1 | February 4, 2013 01:57 |