Surface Wrapping with gap closure

brm123 · June 4, 2015, 16:55

Hello,

I'm trying to close holes by doing a surface wrap.
It's not an option to use a target surface size bigger than the hole size because i want to achieve an accurate wrapping.
To close the holes, I activated "Perform Gap Closure" in the Surface Wrapper Properties and entered a suitable Gap Closure Size.
Unfortunately, this doesn't affect the result. The holes remain in the surface.
Could you please tell me, why this doesn't work and how I can make it work?

me3840 · June 29, 2015, 23:06

Generally I avoid gap closure. It's much easier to ensure you get what you want by either filling or patching over holes. Load up your geometry in surface repair and patch/fill holes to get what you need.

June 4, 2015, 16:55	Surface Wrapping with gap closure	#1
brm123 New Member Join Date: Jun 2015 Posts: 1 Rep Power: 0	Hello, I'm trying to close holes by doing a surface wrap. It's not an option to use a target surface size bigger than the hole size because i want to achieve an accurate wrapping. To close the holes, I activated "Perform Gap Closure" in the Surface Wrapper Properties and entered a suitable Gap Closure Size. Unfortunately, this doesn't affect the result. The holes remain in the surface. Could you please tell me, why this doesn't work and how I can make it work?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Gmsh] Problem with Gmsh	nishant_hull	OpenFOAM Meshing & Mesh Conversion	23	August 5, 2015 02:09
Simulation of varying contact angles for a large droplet of water on a surface	cp703	CFX	5	July 20, 2013 06:08
Comsol (4.3): convert parametric surface into block?	sgalaz	COMSOL	0	November 9, 2012 09:20
CCM+: Surface Wrapping Tutorial	Peter Specht	Siemens	9	March 13, 2008 10:11
surface wrapping takes forever	Kiran	Siemens	3	October 13, 2006 13:01

June 29, 2015, 23:06		#2
me3840 Senior Member Join Date: Nov 2010 Location: USA Posts: 1,232 Rep Power: 24	Generally I avoid gap closure. It's much easier to ensure you get what you want by either filling or patching over holes. Load up your geometry in surface repair and patch/fill holes to get what you need.