Inconstecy in trimmer mesh -- CFD Online Discussion Forums

October 5, 2015, 07:22

Inconstecy in trimmer mesh

cagriaydin

New Member

Çağrı

Join Date: Feb 2015

Posts: 11

Rep Power: 11

Anyone can help me with these inconsistencies in trimmer mesh on naca 0012 airfoil?

I have surface remesher and prism layer enabled. Used custom surface size on airfoil surface.

Attached Images

mesh1.jpg (204.9 KB, 33 views)

October 5, 2015, 20:23		#2
me3840 Senior Member Join Date: Nov 2010 Location: USA Posts: 1,232 Rep Power: 24	Your prisms are collapsing because your trailing edge is sharp. There isn't anything you can do about this other than round the trailing edge.

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] problems generating clean mesh	Christian_tt	OpenFOAM Meshing & Mesh Conversion	2	June 20, 2019 05:39
[ICEM] surface mesh merging problem	everest	ANSYS Meshing & Geometry	44	April 14, 2016 06:41
[ICEM] Mirror Mesh \| Delete duplicate mesh	pythag0ra5	ANSYS Meshing & Geometry	6	November 19, 2013 07:35
erroneous temps in conjugate model?	sieginc.	STAR-CCM+	11	July 14, 2012 03:41
engrid -> save as .stl with boundarie codes	Zymon	enGrid	31	August 29, 2011 13:40

All times are GMT -4. The time now is 08:25.