 |
 |
 |
|
|
|
[Sponsors] | ||||
March 14, 2016, 11:45
|
Mesh area/volume calculations
|
#1 |
|
Senior Member
André
Join Date: Mar 2016
Posts: 133
Rep Power: 10  |
Greetings,
I am quite new to StarCCM and I am working with flow in porous media. One of the quantities of interest is the specific area (m2/m3) of the medium, and I was wondering if I could obtain this by dividing the total surface area of the mesh (which is already defined) by its occupied volume. In theory this should not be quite accurate since it will not compute the solid volume, only the fluid, but still I would like to know if this is possible and easy to do just to get an idea. Thanks in advance for any response!
__________________
Sapere aude! |
|
|
|
|
| Tags |
| foam, mesh, porous, specific area |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
| decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
| [ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
| [ICEM] Problem making structural mesh on a surface | froztbear | ANSYS Meshing & Geometry | 1 | November 10, 2011 08:52 |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
Threaded Mode
