|
[Sponsors] |
August 10, 2016, 04:03 |
Power on specified cells
|
#1 |
New Member
erdal
Join Date: Apr 2014
Posts: 22
Rep Power: 12 |
Hello,
Is it possible to create report for recording the power on specific cells? |
|
August 11, 2016, 16:14 |
|
#2 |
Member
Join Date: Nov 2015
Posts: 38
Rep Power: 10 |
You basically have at least three options:
1. Use the point tool in scene to get the cell center of the cell you want to observe. Therefore move the mouse cursor onto the cell and press the . key. This will report the x,y,z value of the point you selected in the scene. Use these coordinates to create a point probe derived part. Run the report with this point probe as input part. 2. Create a threshold based on the field function prostarCellID and run the report with this threshold as input part. Get the value of the field function in a scalar scene with the point tool mentioned above. 3. Create a cell set by zone select in a scene. You will most likely need multiple subselect steps to only have the single in the cell set in the end. Create a thresold derived part using the cell set field function with a method Above 0.5. Use this threshold as input to the report. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Error in mesh writing | helios | ANSYS Meshing & Geometry | 21 | August 19, 2021 14:18 |
[mesh manipulation] Importing Multiple Meshes | thomasnwalshiii | OpenFOAM Meshing & Mesh Conversion | 18 | December 19, 2015 18:57 |
[snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 09:03 |
snappyHexMesh in parallel - FOAM Fatal IO Error | mturcios777 | OpenFOAM Running, Solving & CFD | 4 | August 10, 2012 19:18 |
physical boundary error!! | kris | Siemens | 2 | August 3, 2005 00:32 |