|
[Sponsors] |
August 17, 2016, 06:53 |
Average flow temperature
|
#1 |
New Member
Join Date: Aug 2016
Posts: 1
Rep Power: 0 |
I'm moddeling a simple pipe 1 m length heated by external heat source.
Is it possible in star-ccm+ to plot some surface average values (temperature/velocity/pressure) over specified direction? I can make a cross-section and report surface average temperature on this section, but I this way I'll have to do over 200 reports to make a plot. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
y+ and u+ values with low-Re RANS turbulence models: utility + testcase | florian_krause | OpenFOAM | 114 | August 23, 2023 05:37 |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 05:21 |
To change temperature in mass flow inlet boundary condition per iteration | ajinkya201991 | FLUENT | 1 | July 11, 2014 11:29 |
Temperature at a velocity/mass flow outlet | saisanthoshm88 | CFX | 1 | July 8, 2014 18:35 |
Difference between Mass Flow Average in CFX and Mass-Weighted Average in Fluent | dasha | ANSYS | 0 | December 21, 2012 04:41 |