|
[Sponsors] |
January 2, 2018, 10:22 |
Multi solid interface mesh
|
#1 |
New Member
Charles Dhainaut
Join Date: Jan 2018
Posts: 1
Rep Power: 0 |
Hello everyone,
I am a very beginner with Starccm+ and I try to mesh a multi solid geometry. I read that I had to create an interface between the two solids to avoid this type of mesh at an interface between two solids : But after I create this interface I don't know what is the procedure to make a smooth mesh at the interface between the two parts. Do you recommend a tutorial to help me to do this ? Thank you very much |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Question about adaptive timestepping | Guille1811 | CFX | 25 | November 12, 2017 17:38 |
Waterwheel shaped turbine inside a pipe simulation problem | mshahed91 | CFX | 3 | January 10, 2015 11:19 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |
Replace periodic by inlet-outlet pair | lego | CFX | 3 | November 5, 2002 20:09 |