 |
 |
 |
|
|
|
[Sponsors] | ||||
April 24, 2020, 06:49
|
Collapsing Prism Layers
|
#1 |
|
New Member
Join Date: Apr 2020
Posts: 8
Rep Power: 6  |
Hi there, I'm relatively new to Star CCm and am having trouble with some collapsing prism layers (See image attached). I have three separate surface controls for the wing (left), hinge (central) and fan (right), each with custom prism layer first cell heights according to their local Re number and custom number of layers.
Should I adjust these controls to all have the same prism layer settings to avoid this collapsing issue? Its quite a key area of interest to my results. Any help appreciated. |
|
|
|
|
| Tags |
| collapsing prism layers |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Collapsing Prism Layers | Jordan1997 | Main CFD Forum | 2 | April 25, 2020 23:06 |
| Prism Layers at Slip Wall to Non-Slip Wall Transition | InfernoxCJC | STAR-CCM+ | 4 | November 26, 2017 19:06 |
| [ICEM] How to improve bad quality elements that are obtained after creating prism layers? | Rohith Giridhar | ANSYS Meshing & Geometry | 2 | July 11, 2015 18:04 |
| [ICEM] Prism layers distorted near trailing edge of blade-Unstructured Mesh | Rohith Giridhar | ANSYS Meshing & Geometry | 3 | June 29, 2015 17:52 |
| ICEM Prism Layer transition between surface with prism layers and one without | TWaung | ANSYS Meshing & Geometry | 2 | October 12, 2009 14:56 |
1Likes
Threaded Mode
