|
[Sponsors] |
EHP plugin with Star-CCM+ only detects hull geometry error after clicking setup |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 29, 2020, 14:37 |
EHP plugin with Star-CCM+ only detects hull geometry error after clicking setup
|
#1 |
New Member
Join Date: Jul 2020
Posts: 1
Rep Power: 0 |
Hello,
I am currently working on my thesis which involves the use of EHP plugin on Star-CCM+ and I am a beginner with using Star-CCM+. The geometry I used is from Maxsurf Academic Samples which I have applied Parametric Transformation on. When I import it on the EHP plugin and check the hull geometry, it says that it does not detect any errors. However, after I click setup the following errors pop up (files attached). I am not sure why this is the case. This is not the geometry ideally wouldn't want to use but because the KCS geometry I have obtained from the Simman website I was hoping I can apply parametric transformation on this geometry and that will have similar dimensions as the KCS hull. Can anyone please help me? |
|
July 31, 2020, 03:28 |
|
#2 |
Senior Member
Ping
Join Date: Mar 2009
Posts: 556
Rep Power: 20 |
i suggest you first import the surfaces into 3D-CAD or Parts and repair the problems highlighted to get a closed surface with no errors then export and try ehp again
|
|
Tags |
ehp, geometry issues, star-ccm |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
problem when imported geometry from 3D CAD to star ccm, | TAREK GANAT | STAR-CCM+ | 1 | May 21, 2013 23:15 |
[Commercial meshers] Using starToFoam | clo | OpenFOAM Meshing & Mesh Conversion | 33 | September 26, 2012 05:04 |
[Other] StarToFoam error | Kart | OpenFOAM Meshing & Mesh Conversion | 1 | February 4, 2010 05:38 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 05:15 |