|
[Sponsors] |
January 1, 2021, 02:32 |
STAR-CCM+ Error
|
#1 |
New Member
Join Date: Dec 2020
Posts: 20
Rep Power: 5 |
Dear all,
I attached an image of an error report that was generated when I was running STAR-CCM+. By the way, am using a POD licence. The STAR-CCM+ simulation was able to complete a 24 hour run just a few hours before this error popped up at the beginning of a restart simulation. I usually run these simulations consecutively with no problem. I have encountered a similar start up error before, and was able to remedy it by simply deleting the hidden App folder containing the temporary STAR-CCM+ files unique to each run. Re-installing the same version also works. However I tried these 2 methods but was unsuccessful in troubleshooting. Please let me know if you have any advice. Best regards |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[swak4Foam] swak4foam openfoam 7 installation problem | Andrea23 | OpenFOAM Community Contributions | 1 | February 17, 2020 18:11 |
Undeclared Identifier Errof UDF | SteveGoat | Fluent UDF and Scheme Programming | 7 | October 15, 2014 07:11 |
OpenFOAM without MPI | kokizzu | OpenFOAM Installation | 4 | May 26, 2014 09:17 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
error while compiling the USER Sub routine | CFD user | CFX | 3 | November 25, 2002 15:16 |