|
[Sponsors] |
March 26, 2021, 06:23 |
Wing Meshing Issues
|
#1 |
New Member
Abdulrahman
Join Date: Nov 2020
Posts: 3
Rep Power: 5 |
Hey guys. I am modelling a tapered and swept 3D wing and I am having trouble with the meshing. In one of the pictures attached is a cross section of the mesh, and it seems like the prism layer is mixing with the poleyhedral mesh. Is this affecting my results? The solution also does not converge using the segregated solver, only with the coupled. y+ values are less than 2 so I assume the mesh is fine enough? Any help would be appreciated.
Screenshot 2021-03-26 141647.png Screenshot 2021-03-26 141751.jpg |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] gmshToFoam generates patches with 0 faces and 0 points | Simurgh | OpenFOAM Meshing & Mesh Conversion | 4 | August 25, 2023 07:58 |
3D wing meshing issues on inlet (ICEM) | sakibrah | ANSYS | 0 | May 5, 2020 03:22 |
[DesignModeler] Meshing a Delta Wing ANSYS CFX - Cannot get inflation around the tip of the wing? | Jack121 | ANSYS Meshing & Geometry | 0 | April 12, 2019 10:08 |
[ICEM] Problem with a C-Grid meshing technique for a wing | GodotMisogi | ANSYS Meshing & Geometry | 1 | May 22, 2017 03:50 |
[GAMBIT] Meshing of flipper wing | dv.darshan | ANSYS Meshing & Geometry | 9 | May 21, 2012 01:38 |