|
[Sponsors] |
April 19, 2021, 05:38 |
Gradually increase cell sizes
|
#1 |
New Member
Join Date: Feb 2021
Posts: 3
Rep Power: 5 |
Hi!
I have a question regarding volume mesh controls. I have a volume mesh of a model of about 150 buldings in Oslo with quite a large domain. (See Picture 1) What I want to know is how this can be changed to have smaller cell sizes towards the bottom, and larger towards the top (meaning it should be almost the same number of cell sizes). I've added an example of how I want the mesh to be (see Picture 2). Is there a way to control this? I hope the question was clear, if not, let me know and I will explain further. Regards Øystein |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Error when setting locationsInMesh | elonesampaio | OpenFOAM Meshing & Mesh Conversion | 1 | April 3, 2021 17:44 |
Cell Reynolds Number | laliong | Main CFD Forum | 12 | September 17, 2019 03:18 |
How to use "translation" in solidBodyMotionFunction in OpenFOAM | rupesh_w | OpenFOAM Running, Solving & CFD | 5 | August 16, 2016 04:27 |
interFoam running blowing up | sandy13 | OpenFOAM Running, Solving & CFD | 2 | May 5, 2015 07:16 |
[snappyHexMesh] snappyhexmesh cell splitted ununiform..2D case | sharonyue | OpenFOAM Meshing & Mesh Conversion | 1 | April 22, 2013 23:34 |