Home > Forums > Software User Forums > Siemens > STAR-CCM+

modeling ablation with star-ccm

Mark Forums Read

Reply

Search this Thread

December 2, 2021, 08:18	modeling ablation with star-ccm	#1
pi120 Member Pietro Join Date: Jun 2021 Location: London Posts: 40 Rep Power: 3	Hi, is it possible to model ablation with star-ccm+? Which physical models need to be used? Example of ablation: the destruction/deterioration of the outer surface of a re-entry vehicle due to excessive high temperatures induced by the flow. Thanks Pietro

Reply

Tags

ablation, coupling, physic model, re-entry

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
problem when imported geometry from 3D CAD to star ccm,	TAREK GANAT	STAR-CCM+	1	May 21, 2013 22:15
[Commercial meshers] Using starToFoam	clo	OpenFOAM Meshing & Mesh Conversion	33	September 26, 2012 04:04
[Other] StarToFoam error	Kart	OpenFOAM Meshing & Mesh Conversion	1	February 4, 2010 04:38
error in star ccm	maurizio	Siemens	3	October 16, 2007 05:17
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15

All times are GMT -4. The time now is 01:08.