 |
 |
 |
|
|
|
[Sponsors] | ||||
April 20, 2011, 18:15
|
Non uniform trimmer mesh?
|
#1 |
|
New Member
Anonymous
Join Date: Apr 2011
Location: Rotherham, England
Posts: 13
Rep Power: 15  |
Hello all,
i'm performing analysis of flow over a step using a trimmer mesh and would really like to experiment with variable mesh sizing. The obvious application would be to make the mesh finer around key points of my (basic) object. In addition the flow over the step comes in axially and thus the depth (z axis) doesnt matter much, is it possible to set the mesh to be wider in this direction, if so how? Thanks! |
|
|
|
|
| Tags |
| non-uniform mesh, trimmer |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| trimmer mesh vs Polyhedral mesh | Marcelo | Siemens | 2 | February 4, 2015 09:00 |
| 3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 06:42 |
| [Commercial meshers] Converting a mesh with splitted cells using fluentMeshToFoam | jlpelerin | OpenFOAM Meshing & Mesh Conversion | 4 | April 25, 2011 16:56 |
| buoyantSimpleRadiationFoam | msarkar | OpenFOAM | 0 | February 15, 2010 06:22 |
| Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |
Threaded Mode
