 |
 |
 |
|
|
|
[Sponsors] | ||||
April 22, 2011, 12:49
|
Ramping Courant Number
|
#1 |
|
New Member
Martin
Join Date: Nov 2010
Posts: 23
Rep Power: 15  |
A quick query about the 'ramping' of values in StarCCM+.
As I am running a highly hypersonic case the starting Courant number had to be small, but I have put a rampping function in to gradually increase the value over a number of iterations. The set up in Star is straight forwards with a start and end iteration, and a initial Courant number defined. But what I could not gather from the UG was a what value does the Courant number reach or plateau out at, or is this just dependednt on the solution and applies the maximum value it can? Cheers, Martin |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [mesh manipulation] Mesh Refinement | Luiz Eduardo Bittencourt Sampaio (Sampaio) | OpenFOAM Meshing & Mesh Conversion | 42 | January 8, 2017 12:55 |
| DecomposePar unequal number of shared faces | maka | OpenFOAM Pre-Processing | 6 | August 12, 2010 09:01 |
| Unaligned accesses on IA64 | andre | OpenFOAM | 5 | June 23, 2008 10:37 |
| Could anybody help me see this error and give help | liugx212 | OpenFOAM Running, Solving & CFD | 3 | January 4, 2006 18:07 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Threaded Mode
