|
[Sponsors] |
October 27, 2011, 20:36 |
wrong values for resistance
|
#1 |
New Member
Eran
Join Date: Sep 2011
Location: Massachusetts
Posts: 11
Rep Power: 14 |
Hi,
I am running a ship's hull fixed (not 6dof) with slow speed current. i am getting very accurate result for the frictional resistance (about 3% from ITTC formula) but very low pressure drag (half from what was found in tow tank). what could be wrong? E. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
It would be wonderful if a tool for FoamToTecplot is available | luckyluke | OpenFOAM Post-Processing | 165 | November 27, 2012 06:54 |
BuoyantBoussinesqSimpleFoam and axial-symmetric results wrong mass flow | Thomas Baumann | OpenFOAM | 6 | December 21, 2009 10:31 |
Cd values for 3D rectangular cylinder | karthik | FLUENT | 1 | August 28, 2009 06:32 |
CFD VALUES AT EXPERIMENTAL POINT | J | FLUENT | 1 | September 25, 2005 16:55 |
Y+ Values for a sperating flow over a hill | Dave | FLUENT | 2 | July 9, 2005 23:18 |