The energy balance in star-ccm???

xinzhiyu2008 · January 13, 2012, 03:44

i finished a simulation,but i don't know if the energy is balancing,i don't know which report is the correct one to see the energy balance, please tell me! THANKS

sanjay · January 13, 2012, 04:36

define your question correctly!!! its not clear

regards
www.aerosapien.blogspot.com

willimanili · January 13, 2012, 17:41

Usually you create some reports of engineer values you are interested in before you start the solver. For example: massflowaveraged report of temperature for boundaries or derived parts like section planes, heattransfer report for interfaces, surfaceaveraged temperature reports....

Create some monitors and plots of your reports, so you can see if the solution is getting converged or not.

January 13, 2012, 03:44	The energy balance in star-ccm???	#1
xinzhiyu2008 New Member Leon Join Date: Aug 2010 Posts: 10 Rep Power: 14	i finished a simulation,but i don't know if the energy is balancing,i don't know which report is the correct one to see the energy balance, please tell me! THANKS

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Using starToFoam	clo	OpenFOAM Meshing & Mesh Conversion	33	September 26, 2012 04:04
volumetric reaction and energy balance?	m.beh	FLUENT	1	October 17, 2011 17:21
ATTENTION! Reliability problems in CFX 5.7	Joseph	CFX	14	April 20, 2010 15:45
[Other] StarToFoam error	Kart	OpenFOAM Meshing & Mesh Conversion	1	February 4, 2010 04:38
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues	michele	OpenFOAM Meshing & Mesh Conversion	2	July 15, 2005 04:15

January 13, 2012, 04:36		#2
sanjay Member aerosapien Join Date: Sep 2010 Posts: 59 Rep Power: 14	define your question correctly!!! its not clear regards www.aerosapien.blogspot.com

January 13, 2012, 17:41		#3
willimanili Member Join Date: Feb 2011 Location: DE-PB Posts: 56 Rep Power: 14	Usually you create some reports of engineer values you are interested in before you start the solver. For example: massflowaveraged report of temperature for boundaries or derived parts like section planes, heattransfer report for interfaces, surfaceaveraged temperature reports.... Create some monitors and plots of your reports, so you can see if the solution is getting converged or not.