|
[Sponsors] |
September 8, 2018, 10:03 |
Semi Eliptical Crack fracture Ansys
|
#1 |
New Member
José Rodrigues Pereira Corrêa
Join Date: Nov 2017
Posts: 4
Rep Power: 8 |
I am doing the same estudy and when the results it is solved I receive a error mensager "A fracture result is specified by time instead of by set. If the time lies between two result sets, no interpolation is performed. Instead, there are two possibilities: (1) if there are no mesh changes, the lower set applies; (2) if there are mesh changes, the closest set applies"
I receive the value 1157,2Mpa.mm^(0,5), but in my calculation should be close to 1608,92 according Abaqus or 1726,55 according API standard. someone could help me? semi eliptical external crack dimension (longitudinal direction): 63,2mm major radius 15,8mm minor radius pipe external radius: 1158,8mm pipe internal radius: 1139,8mm pipe lenght: 800mm Internal pressure: 3.5Mpa |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Command Line Run for ANSYS | Liaquat | ANSYS | 11 | April 19, 2018 09:49 |
how to map resultd from cfx to ansys? | ritesh | CFX | 2 | June 1, 2011 07:52 |
How to model concrete slab in ANSYS and apply 2 million cyclic load. | jjc | ANSYS | 3 | April 12, 2011 04:47 |
Difference between ANSYS CFD & CFD | solamy | ANSYS | 3 | October 21, 2010 16:06 |
Exporting results from CFX to ANSYS ?? | sohail ahmed | CFX | 1 | December 20, 2007 01:10 |