Target y+ for Euler mesh

tjim · December 10, 2018, 04:11

Hi all,

Sorry, this may be a really simple question; in SU2, is there a specific target y+ that one should aim for when meshing for the Euler solver?

Many thanks and kind regards,
Tim

aero_amit · December 10, 2018, 09:10

Wall y+ is a non-dimensional parameter.
It is an important parameter and used with turbulence models to calculate or check the first cell height for a given turbulence model/approach (wall function or solve to the wall).
For euler simulations you are only solving invicid flow and fine stretched grid to resolve boundary layer is not required. So you can simply have a mesh good enough to resolve flow features in the field like contact discontinuity or shock etc..

tjim · December 10, 2018, 23:12

Thanks for the reply. That makes sense - I haven't touched CFD in a while, so I could only recall needing different y+ values for different wall functions, which is only a concern in turbulence modelling and RANS! I guess all I need is sufficient mesh density to resolve my flow feature of interest then.

Kind regards,
Tim

December 10, 2018, 04:11	Target y+ for Euler mesh	#1
tjim New Member Tim Jim Join Date: Sep 2017 Posts: 25 Rep Power: 9	Hi all, Sorry, this may be a really simple question; in SU2, is there a specific target y+ that one should aim for when meshing for the Euler solver? Many thanks and kind regards, Tim

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Building OpenFOAM1.7.0 from source	ata	OpenFOAM Installation	46	March 6, 2022 13:21
[snappyHexMesh] Add Mesh Layers doesnt work on the whole surface	Kryo	OpenFOAM Meshing & Mesh Conversion	13	February 17, 2022 07:34
AMI speed performance	danny123	OpenFOAM	21	October 24, 2020 04:13
decomposePar problem: Cell 0contains face labels out of range	vaina74	OpenFOAM Pre-Processing	37	July 20, 2020 05:38
[snappyHexMesh] Snappyhex mesh: poor inlet mesh	Swagga5aur	OpenFOAM Meshing & Mesh Conversion	1	December 3, 2016 16:59

December 10, 2018, 09:10		#2
aero_amit Member Amit Join Date: May 2013 Posts: 85 Rep Power: 13	Wall y+ is a non-dimensional parameter. It is an important parameter and used with turbulence models to calculate or check the first cell height for a given turbulence model/approach (wall function or solve to the wall). For euler simulations you are only solving invicid flow and fine stretched grid to resolve boundary layer is not required. So you can simply have a mesh good enough to resolve flow features in the field like contact discontinuity or shock etc..

December 10, 2018, 23:12		#3
tjim New Member Tim Jim Join Date: Sep 2017 Posts: 25 Rep Power: 9	Thanks for the reply. That makes sense - I haven't touched CFD in a while, so I could only recall needing different y+ values for different wall functions, which is only a concern in turbulence modelling and RANS! I guess all I need is sufficient mesh density to resolve my flow feature of interest then. Kind regards, Tim