 |
 |
 |
|
|
|
[Sponsors] | ||||
May 25, 2019, 12:21
|
3d print process
|
#1 |
|
New Member
Join Date: May 2019
Posts: 2
Rep Power: 0  |
Hi community,
what is the best method to simulate the 3d printing process by using a polymere, a heater and a ground plate? So: polymere in heater. Heater melts it. Melted liquid hits the ground and cools down. Object is printed layer by layer. Do you know any method so simulate this process? I heard of VOF and finite difference method (fdm) method. Thank you very much |
|
|
|
|
 |
| Tags |
| 3d print process, simulation |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Parallel fluent process exiting before reading the mesh file | harsha2398 | FLUENT | 3 | December 29, 2020 00:58 |
| simulation of 3d print process using a polymere and a heater | tnevel | OpenFOAM | 1 | May 27, 2019 06:01 |
| Hybrid discretisation - blend factor | gcoopermax | CFX | 5 | September 23, 2016 08:05 |
| The fl process could not be started because of UDF | majid_kamyab | Fluent UDF and Scheme Programming | 6 | December 15, 2015 08:42 |
| [blockMesh] Another cylinder question | bendel_boy | OpenFOAM Meshing & Mesh Conversion | 5 | January 6, 2015 05:09 |
Linear Mode
