|
[Sponsors] |
March 19, 2013, 12:32 |
smooth contour over zones
|
#1 |
Member
Dokeun, Hwang
Join Date: Apr 2010
Location: Korea, Republic of
Posts: 98
Rep Power: 16 |
Dear all
I plotted 2D contour for the cell-centered result which has 2 zones. As you can see from the attached picture, a contour is not smooth over the zones. How can I make this continuously? Below is a part of my ASCII data --------------------------------- Title = "Grid" Filetype = Full Variables = "x", "y", "rho", "u", "v", "p", "Mach" Zone T = "zone01" Nodes= 373, Elements= 666 Datapacking=Block, Zonetype=FEQuadrilateral, VarLocation=([3-7]=CELLCENTERED) FACENEIGHBORCONNECTIONS= 1938 FACENEIGHBORMODE=GLOBALONETOONE FEFACENEIGHBORSCOMPLETE=YES DT=( DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE ) ~~~ Zone T = "zone02" Nodes= 729, Elements= 1340 Datapacking=Block, Zonetype=FEQuadrilateral, VarLocation=([3-7]=CELLCENTERED) FACENEIGHBORCONNECTIONS= 3922 FACENEIGHBORMODE=GLOBALONETOONE FEFACENEIGHBORSCOMPLETE=YES DT=( DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE DOUBLE ) ~~~ ------------------------------------------------------------------ I checked connectivity list but there is no problem Last edited by dokeun; March 19, 2013 at 21:34. Reason: add zone header |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Skipping Zones | 1337Hal | FLUENT | 1 | June 27, 2022 09:33 |
[GAMBIT] Plotting/Meshing a Contour Map (3D hill) | VU_Engineer | ANSYS Meshing & Geometry | 6 | January 28, 2014 06:59 |
Contour Problem in Interface Boundary | inra | FLUENT | 1 | May 29, 2010 05:22 |
How Manage the contour of pressure?? | teguhtf | FLUENT | 2 | January 1, 2010 04:49 |
Importing contour maps into Tecplot | jcostex | Tecplot | 1 | May 20, 2009 12:48 |