|
[Sponsors] |
May 19, 2023, 14:13 |
How to show all zone in tecplot?
|
#1 |
New Member
jeff lin
Join Date: May 2023
Posts: 1
Rep Power: 0 |
Hello,
I am doing a fluid-solid coupling simulation. I exported case/data files (cas.gz/dat.gz) from Ansys Fluent. I loaded these files in the Tecplot, it can't show all the zones and can't open from Zone Style, but when I export the plt files from Ansys Fluent, it can show all the zones. How can I use case/data files to show all zones? Thank you in advance! |
|
May 22, 2023, 14:43 |
|
#2 |
Member
Brandon M
Join Date: Feb 2019
Posts: 38
Rep Power: 7 |
Hi Jeff, are you able to share your data? If so, could you email support@tecplot.com and Tecplot Support can take a look at that data? Additionally, there was a maintenance release of 2022R2 recently released that updated the legacy Fluent loader (*.dat/*.cas) to better handle transient data with particle zones. In the 2022 R2 Maintenance release, solution times should be assigned correctly, and all particle zones should be grouped into the same time strand.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
duplicated zones don't show up in zone style | shatarah | Tecplot | 2 | December 13, 2021 11:52 |
How to show all time zone in tecplot? | haizhou0410 | Tecplot | 2 | November 24, 2020 04:06 |
[mesh manipulation] RefineMesh Error and Foam warning | jiahui_93 | OpenFOAM Meshing & Mesh Conversion | 4 | March 3, 2018 11:32 |
Tecplot 360 2017 Release 2 | manohar1487 | Main CFD Forum | 0 | August 28, 2017 02:08 |
[blockMesh] StitchMesh on two patches | anita | OpenFOAM Meshing & Mesh Conversion | 31 | April 4, 2013 11:51 |