 |
 |
 |
|
|
|
[Sponsors] | ||||
November 21, 2023, 09:37
|
How to delete triple cons
|
#1 |
|
New Member
VENKATESH
Join Date: Nov 2023
Posts: 1
Rep Power: 0  |
I am beginner in ANSA software. I am facing difficulties to delete triple cons. Can any one explain step by step process to delete tripple cons
|
|
|
|
|
|
April 19, 2024, 10:46
|
|
#2 |
|
Senior Member
Vangelis Skaperdas
Join Date: Mar 2009
Location: Thessaloniki, Greece
Posts: 287
Rep Power: 21 |
Hi there
Triple CONS indicate that 3 or more Faces are connected on the same line. It could be either duplicate or overlapping faces, Triple T-junctions etc You can either Delete some Faces, so that you only leave two Faces connected, or release the connectivity using Hot Points Release to disconnect the area |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Action Subtract or delete doesn't work in OpenFOAM | TGS | Main CFD Forum | 1 | August 16, 2023 10:52 |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
| [ICEM] Delete family part not possible | FluidCFD | ANSYS Meshing & Geometry | 6 | April 4, 2014 08:57 |
| Fuel Triple Points | arun | OpenFOAM Programming & Development | 0 | August 17, 2010 00:38 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Linear Mode
