|
[Sponsors] |
June 11, 2012, 11:49 |
Problem with merging edges/faces
|
#1 |
Member
Bahar
Join Date: May 2012
Posts: 46
Rep Power: 14 |
Hello everybody,
I have a problem while importing geometry from Solid Works to Gambit. As showed in figures, there are 3 blades that would be meshed. But every side edges of blades has broken in two edges while there are circles in leading edge and trailing edges. So when I mesh the airfoil it wouldn't get a smooth mesh because of difference in scale of edges. I tried to merge them but while the geometry is complex, it could not create a real face/edge. Is there any idea to resolve this problem? Thank you in advance, bahar |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
conduction problem | venkataramana | OpenFOAM | 3 | December 1, 2013 07:30 |
UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
ICEM mesh merging problem | Serge | CFX | 2 | October 22, 2007 06:13 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |