|
[Sponsors] |
June 25, 2012, 04:40 |
length of recirculation zone
|
#1 |
New Member
abc
Join Date: Jun 2012
Posts: 4
Rep Power: 13 |
hi,
i was examining the velocity flow pattern and recirculation zones in a t-junction with two different meshing(one a coarser one and the other is the finer one) in fluent. But i am facing a problem in fluent that the length of recirculation zone with coarser grid is more reasonable than that with finer grid at same reynolds number. All the operating conditions as well as grid parameters have been kept same except the extent of meshing(fine and coarse). Please help me out. |
|
June 26, 2012, 03:12 |
|
#2 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
are your y+ still ok with fine grid?
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem | Attesz | OpenFOAM Meshing & Mesh Conversion | 12 | May 2, 2013 10:52 |
[Technical] length of recirculation zone | abc | OpenFOAM Meshing & Mesh Conversion | 0 | June 25, 2012 04:36 |
[ICEM] Export ICEM mesh to Gambit / Fluent | romekr | ANSYS Meshing & Geometry | 1 | November 26, 2011 12:11 |
Problem in running ICEM grid in Openfoam | Tarak | OpenFOAM | 6 | September 9, 2011 17:51 |
Problem in IMPORT of ICEM input file in FLUENT | csvirume | FLUENT | 2 | September 9, 2009 01:08 |