 |
 |
 |
|
|
|
[Sponsors] | ||||
July 20, 2012, 11:34
|
PRISM at different places
|
#1 |
|
New Member
Huihui Wang
Join Date: Jul 2012
Location: Mississippi
Posts: 17
Rep Power: 13  |
I try to make prism at the bed of the container, and around the pipe.
7.20.jpg in the bed of the container, it is ok to be generated. but around the pipe, I can't get the prism layers. why it's like this? any method can fix it? what i did is make the round surface to be prismed, like the bottom surface. anything wrong? THANKS! HUIHUI |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Getting prism to inflate into mixed tet-hex meshes | Joe | CFX | 16 | October 10, 2011 07:06 |
| ICEM Prism Layer transition between surface with prism layers and one without | TWaung | ANSYS Meshing & Geometry | 2 | October 12, 2009 14:56 |
| Trimmer & prism layer | peresah | STAR-CCM+ | 6 | October 6, 2009 14:39 |
| ICEM - Prism Tool Problem | carpe85 | CFX | 0 | February 10, 2009 12:25 |
| Icemcfd: Preventing prism inflation collisions? | Joe | CFX | 1 | July 31, 2007 09:13 |
Threaded Mode
