|
[Sponsors] |
August 14, 2012, 16:19 |
low angle quality at Y-grid
|
#1 |
Member
venkatesh
Join Date: May 2012
Posts: 93
Rep Power: 13 |
Hi,
I am meshing propeller blade. I had inserted Y-block at the tip of the propeller blade. In the region of Y-block, i have low angle quality as shown in figure1. Is there any way to improve the angle at the tip of the propeller. Files can be downloaded form the following link. https://www.dropbox.com/sh/c6e3l1hh0o1f32a/pxjVod6pAW |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to deal with sharp trailing edges in icem | joegi.geo | ANSYS Meshing & Geometry | 31 | March 5, 2018 20:57 |
[ICEM] Low quality Tet prism mesh | saisanthoshm88 | ANSYS Meshing & Geometry | 17 | September 28, 2016 17:50 |
[ICEM] Low quality mesh | Memme | ANSYS Meshing & Geometry | 1 | May 25, 2012 03:02 |
[Netgen] Import netgen mesh to OpenFOAM | hsieh | OpenFOAM Meshing & Mesh Conversion | 32 | September 13, 2011 06:50 |
Grid Independent Solution | Chuck Leakeas | Main CFD Forum | 2 | May 26, 2000 12:18 |