[GAMBIT] Meshing 3-D pipe problem -- CFD Online Discussion Forums

August 15, 2012, 17:52	Meshing 3-D pipe problem	#1
shayan_mv New Member shayan Join Date: Jul 2012 Location: Australia Posts: 27 Rep Power: 13	Hello Dears I am beginner with Fluent so facing many questions! I plan to create a curved simple 3-d pipe and want to get contours at some sections. 1. Should I make a face at each angle that I need contour? 2. Does each face need special mesh or by meshing the whole volume, no need for meshing the mentioned faces? 3.what about meshing the edges e.g. at inlet? Thank you Last edited by shayan_mv; August 16, 2012 at 04:12.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Other] Hex meshing problem DM12	patrick	ANSYS Meshing & Geometry	7	January 9, 2015 07:21
Gambit - meshing over airfoil wrapping (?) problem	JFDC	FLUENT	1	July 11, 2011 05:59
[Commercial meshers] problem meshing two interacting volumes	banerji	OpenFOAM Meshing & Mesh Conversion	0	December 14, 2009 15:59
Meshing problem	akr	FLUENT	2	February 3, 2008 20:22
meshing hollow part of pipe	rai	FLUENT	0	December 19, 2005 00:46

All times are GMT -4. The time now is 15:24.