[mailpulak]

Thanks, I'll try that.

[mailpulak]

The mapped face meshing is not working.. If there is a way/setting to achieve can anyone let me know..

Thanks.

[Jinglz]

Insert "sizing"> select the 4 edges > num of divisions

Put the same number for all the sides for now...say 25

Insert "mapped face" mesh on that face

Insert "Method" > "Sweep" >put 100 divisions for now

That should get you close. For these steps the order matters.

[samidabest]

i draw the 2d model in the ansys when i did meshing on it, it show 3d figure in meshing but in geometry it show 2d.... so what i do...... help me

[diamondx]

when meshing a 2d geometry. sketch has to be done in XY plane. Very important. when you close the geometry window, in the workbench look a the right panel and select 2D instead of 3d in geometry properties. have you done that ?

[samidabest]

yes i done this already but problem is there