 |
 |
 |
|
|
|
[Sponsors] | ||||
December 16, 2012, 05:53
|
Sliding Mesh
|
#1 |
|
New Member
Jose
Join Date: Nov 2012
Posts: 2
Rep Power: 0  |
Hi there,
I need to make a sliding mesh to simulate a propeller, but I don't know how make the mesh. I've tried many ways to make it but when I start the setup in Fluent always get an error that says: "information model may not be compatible with mesh". I want the small cylinder be the sliding mesh. I have seen that I have to make all the geometry as a only one part, but I'm not sure if this is true. Thanks a lot beforehand. |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Moving mesh | Niklas Wikstrom (Wikstrom) | OpenFOAM Running, Solving & CFD | 122 | June 15, 2014 06:20 |
| 3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 06:42 |
| [snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 09:03 |
| [snappyHexMesh] external flow with snappyHexMesh | chelvistero | OpenFOAM Meshing & Mesh Conversion | 11 | January 15, 2010 19:43 |
| dynamic mesh and sliding mesh | nasser | FLUENT | 0 | November 1, 2005 02:37 |
Threaded Mode
