|
[Sponsors] |
January 21, 2013, 08:21 |
problem of visualization mesh
|
#1 |
Senior Member
Talles Caio
Join Date: Oct 2012
Location: Brazil
Posts: 101
Rep Power: 13 |
I'm working with ICEM 13.0, I finished doing the blocking, but when active the option pre-mesh I'm not able to visualize the mesh geometry, but it shows on the display the following information:
Number of processors = 1 Done recompute Mesh size: NODE: 386 LINE_2: 0 TRI_3: 0 QUAD_4: 1266 TETRA_4: 0 HEXA_8: 316 PENTA_6: 0 PYRA_5: 0 all functions of geometry and block are enabled!, anyone know why not able to see the generated mesh geometry? |
|
January 21, 2013, 09:32 |
|
#3 |
Senior Member
Talles Caio
Join Date: Oct 2012
Location: Brazil
Posts: 101
Rep Power: 13 |
||
January 21, 2013, 15:29 |
|
#5 |
Senior Member
Talles Caio
Join Date: Oct 2012
Location: Brazil
Posts: 101
Rep Power: 13 |
||
January 21, 2013, 15:47 |
|
#6 |
Super Moderator
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Posts: 1,385
Blog Entries: 23
Rep Power: 28 |
You'll find that on the blocking tab in edge parameters. Have you done some tutorials ?? These are very basic operation that you can find in the tutorials ...
|
|
January 22, 2013, 08:58 |
|
#7 |
Senior Member
Talles Caio
Join Date: Oct 2012
Location: Brazil
Posts: 101
Rep Power: 13 |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dynamic Mesh Problem. | Tom Clark | FLUENT | 10 | June 21, 2021 04:27 |
Gambit problems | Althea | FLUENT | 22 | January 4, 2017 03:19 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |
Convergence problem when ustructured mesh is used. | SangJin Ryu | Siemens | 3 | October 5, 2000 20:26 |