[Smaras]

Hello CFD _users,

I am having trouble with my tetra mesh. And the quality is not good.

I am adding the pictures and requires your professional advise for the betterment.





And the .tin and .prj file is attached for your perusal.

https://www.dropbox.com/sh/d30ev50rvlz0a3c/twtzassjOc

Waiting for your kind replies. Thanks

Regards,
Smaras

[Smaras]

I have used Delauney method too and getting even worst quailty

[j_h_86]

Originally Posted by Smaras

I have used Delauney method too and getting even worst quailty

Hey Smaras,

I have looked into your project. Before I dig deeper I have one general question: was it your intention that no prism layers were generated?

[Smaras]

Originally Posted by j_h_86

Hey Smaras,

I have looked into your project. Before I dig deeper I have one general question: was it your intention that no prism layers were generated?

No i want prism layers, as well.

[RodriguezFatz]

Hi Smaras, why do you use tetra at all? Why not hexa? Blocking should be pretty easy for such a simple geometry...

[Smaras]

Originally Posted by RodriguezFatz

Hi Smaras, why do you use tetra at all? Why not hexa? Blocking should be pretty easy for such a simple geometry...

Hello Rodriguez, its the requirement for the job i am doing. This is not the original geometry. And i know blocking would be suitable, but the requirement is of Tetra mesh.
Hope there would be a solution for this problem.