|
[Sponsors] |
March 12, 2013, 03:43 |
How can i Check 'Y PLUS' In gambit?
|
#1 |
New Member
Yang Ju-Suk
Join Date: Mar 2013
Posts: 5
Rep Power: 13 |
I want to use SST k-omega model in fluent.
I usually use gambit as mesh generator. And I want to check Y PLUS in gambit. How can i check Y PLUS in gambit? |
|
March 12, 2013, 04:03 |
|
#2 |
Super Moderator
Alex
Join Date: Jun 2012
Location: Germany
Posts: 3,399
Rep Power: 46 |
Yplus is computed by the flow solver and thus not available in your meshing tool.
You will have to check the Yplus-values in fluent after a simulation. |
|
March 13, 2013, 05:18 |
|
#3 |
Senior Member
Lance
Join Date: Mar 2009
Posts: 669
Rep Power: 22 |
there's a way to estimate the y+, see http://www.cfd-online.com/Tools/yplus.php
|
|
March 13, 2013, 06:27 |
thank you
|
#4 |
New Member
Yang Ju-Suk
Join Date: Mar 2013
Posts: 5
Rep Power: 13 |
thank you!
so helpful |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to open a saved Gambit File? | barkan | FLUENT | 5 | September 1, 2012 05:53 |
[ICEM] Gambit to ICEM, any advices ? | Santos-Dumont | ANSYS Meshing & Geometry | 15 | February 28, 2012 19:07 |
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 05:22 |
Problems in compiling paraview in Suse 10.3 platform | chiven | OpenFOAM Installation | 3 | December 1, 2009 07:21 |
between IDL Gambit and rhino, any help? | philip | FLUENT | 0 | June 23, 2005 12:08 |