|March 12, 2013, 04:43||
How can i Check 'Y PLUS' In gambit?
Join Date: Mar 2013
Posts: 5Rep Power: 5
I want to use SST k-omega model in fluent.
I usually use gambit as mesh generator.
And I want to check Y PLUS in gambit.
How can i check Y PLUS in gambit?
|March 12, 2013, 05:03||
Join Date: Jun 2012
Posts: 1,311Rep Power: 22
Yplus is computed by the flow solver and thus not available in your meshing tool.
You will have to check the Yplus-values in fluent after a simulation.
|Thread||Thread Starter||Forum||Replies||Last Post|
|How to open a saved Gambit File?||barkan||FLUENT||5||September 1, 2012 05:53|
|[ICEM] Gambit to ICEM, any advices ?||Santos-Dumont||ANSYS Meshing & Geometry||15||February 28, 2012 20:07|
|[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing||David-CFD||ANSYS Meshing & Geometry||1||April 1, 2011 05:22|
|Problems in compiling paraview in Suse 10.3 platform||chiven||OpenFOAM Installation||3||December 1, 2009 08:21|
|between IDL Gambit and rhino, any help?||philip||FLUENT||0||June 23, 2005 12:08|