|
[Sponsors] |
July 31, 2016, 16:53 |
ICEMCFD "ogrid not successful" error
|
#1 |
New Member
Amet
Join Date: Jul 2016
Posts: 12
Rep Power: 9 |
Hello, I'm new to icemcfd.
I drew the model and i transferred ICEM CFD. There is no gap. i associated edge to curve and then i want to ogrid block but i didn't this. I sent in additional error screenshot |
|
August 1, 2016, 06:53 |
|
#3 |
New Member
Amet
Join Date: Jul 2016
Posts: 12
Rep Power: 9 |
Yes i used around option and i splitted body
i sent wrong picture sorry |
|
August 1, 2016, 07:24 |
|
#5 |
New Member
Amet
Join Date: Jul 2016
Posts: 12
Rep Power: 9 |
i didn't delete any body. before start icemcfd, i did boolean and i subtracted face so there was a gap below.
this could be caused? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] blockMesh with double grading. | spwater | OpenFOAM Meshing & Mesh Conversion | 92 | January 12, 2019 09:00 |
[OpenFOAM] Native ParaView Reader Bugs | tj22 | ParaView | 270 | January 4, 2016 11:39 |
[swak4Foam] installing funkySetFields | igo | OpenFOAM Community Contributions | 1 | November 20, 2012 20:16 |
Ansys Fluent 13.0 UDF compilation problem in Window XP (32 bit) | Yogini | Fluent UDF and Scheme Programming | 7 | October 3, 2012 07:24 |
DecomposePar links against liblamso0 with OpenMPI | jens_klostermann | OpenFOAM Bugs | 11 | June 28, 2007 17:51 |